Questions & Answers for: door module crown victoria

crown vic with ATC have you tried replacing the blower resister module? Have you checked Fuse F1.103 40Amp in the Battery Junction Box? You also have the Blower Motor Relay located in the BJB which is

Digital dash and interior lights and power door locks not working, all fuses and circuit breakers are good. Body Control Module and/or associated wiring with it. Check your grounds.

...rear the light goes out when the a door is open, when doors are closed the lamps do not work when click on them. The lamps could be defective or there could be a defect in the lighting control

lock module for 2001 ford crown vic it is located in the drivers door

glove box (on the sides, or the outsides of the pouch) and they are on the door module, located behind the glovebox. If you go the dealer route, you might have to do it in person (with an owners card)

...module bad blows through defroster only I can't say 100% on this but some vehicles still use vacuum to operate the blend air doors (electric solenoids or earlier cable to operate the tempature ...

directly off the door switch or gone to the control module. When I fit alarms I always find it more reliable to go to the vehicles door switch directly as you will get a direct earth switch there. Jon

...door is obviously closed Perhaps the switch is bad, or a short to ground. I would check the switch, and if that is good, trace out the circuit to find the trouble. That car has a lighting control ...

...door & remote too. I replaced battery on the remote I checked the fuse in the fuse box. What else could it be?! The locks are controlled by a module commonly called the BCM (body control module) it ...

door handle then reassemble it ?????? did you check to make sure the child safety locks are not on ??? also your car may have the dark out system activated and you have to go to the dealer for that so