Questions & Answers for: distributor cap removal

...cap. Distributor holddown washers and nuts and torque to 9 ft. lbs (13 Nm) EGR tube. Air inlet tube, resonator and air cleaner cover. Hose clamp at throttle body. PCV make-up air hose from air inlet ...

Ad

Question about 1994 Grand Cherokee

2 Answers

...distributor cap on 5.2 l v8. I need to remove my distributor cap and can't see how it is fastened behind the engine. Are there snaps, bolts (with or without screw slots)? If bolts what size are they? ...

Ad

...distributor cap and remove the cap. Remove the bolt securing the distributor. Disconnect the crank angle sensor connector and remove the distributor. Install the distributor, making sure the rotor is ...

Question about 1996 Corolla

2 Answers

distributor cap. Label and disconnect the wires from the cap. On some engines it will be necessary to use a flat bladed tool to lift up the lock claw and disconnect the holder from the cap. Fig. 5: On

Question about 2000 Jimmy

1 Answer

...cap 4.3L Distributor rotor screws removal Rotor screws Rotor 4.3L Align reluctor wheel slot with CMP Align the square slot in the reluctor wheel with the CMP sensor 4.3L CMP sensor screws removal ...

...distributor cap, and position aside. Unfasten the 2 coil cover attaching screws, then lift the cover off. Remove the 4 coil-to-cap attaching screws and lift the ignition coil and leads from the cap. ...

Question about 1993 Corvette

1 Answer

...DISTRIBUTOR CAP BEFORE REMOVING CAP. SO YOU CAN PUT PLUGS WIRES BACK IN THE ORIGINAL POSITION. WHEN ALL PLUGS WIRES ON DISTRIBUTOR CAP BEEN NUMBER.REMOVE ALL PLUG WIRES ON CAP.THEN REMOVE THE ...

Question about 1993 Corvette

1 Answer

...distributor cap. Loosen distributor cap hold-down screws and remove cap. Mark rotor position for installation reference, then remove rotor. Remove two harness connectors from distributor. Remove two ...

Question about 1992 Tempo

2 Answers

...distributor cap.mark location distributor cap.number tag plug wires on the distributor cap so you can remove plug wires on distributor cap so you can replace cap and rotor and put wires back on the ...

...distributor cap is to be replaced, mark the ignition wires for identification and remove them from the distributor cap.Remove any components necessary to access the distributor cap.Completely loosen ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...