Questions & Answers for: connecting radio wires

...wires? (radios with 3 power leads) Answer: Connect the black wire to chassis ground. Connect the red wire to a switched +12 volt source, such as the fuse for the AM/FM radio. The orange wire is for ...

...radio works fine). I have two wires that are not connected. Radio illumination wire(red/blue) & radio dimmer wire(red/yellow) were do i connect them?? check this web site ,it might help with your ...

...radio's power wires (and attach the new radio's ignition power wire, or switching wire to the positive power wire from your vehicle too). The point will be to get power to the new radio so that you ...

hi, just trying to wire up my pioneer gm-620 car amp and having some problems with which wire goes where, due to not having a wiring diagram. (red is live) (black is ground) but i dont know where the ...

...wires when the key is on. If there is power there, you may have got hold of a bad radio. 1990 Toyota Celica Car Stereo Radio Wiring Diagram Radio Constant 12V+ Wire: Blue/Yellow, connects to yellow ...

...of the battery. All three wires need to be connected to operate as expected. Hopefully, one of these wires is not connected properly and you'll have your radio working in a very short time. Good

To which terminals do I connect the power leads to the radio of a 1957 Corvette? the radio has been upgraded to an AM/FM using the factory receiver; the old leads connect to the light switch gray wire

...RADIO DIGRAM Here is the wiring diagram for connecting a D104-M6B microphone to a Uniden 880 radio: Shield: Connect to pin 1 of the microphone jack on the radio White: Connect to pin 2 of the ...

...radio requires connecting the wires from the microphone to the corresponding pins on the radio's microphone jack. Here are the steps: Locate the microphone jack on the front of the Cobra 29 LTD ...

...to the accessory power, the yellow wire connects to the constant power, the black wire connects to the ground, and the speaker wires are color-coded to match the corresponding wires on the