Questions & Answers for: Dodge s m a r t command failed

...as if not stubbier sending the alternator, i will send to review and apparently this good, it was command to check the computer and wiring and this good, according to the mechanical tells me that ...

...minimum or maximum allowable calibrated parameters for a specified canister vent duty cycle by PCM command. Symptoms: You will likely not notice any drivability problems. Causes: A code P1451 may ...

...minimum or maximum allowable calibrated parameters for a specified canister vent duty cycle by PCM command. Symptoms: You will likely not notice any drivability problems. Causes: A code P1451 may ...

...command a fixed position with a scan tool the valve should open to that position and hold. If the valve moves in and out when commanded to a fixed value then the position sensor inside the valve has ...

...minimum or maximum allowable calibrated parameters for a specified canister vent duty cycle by PCM command. Symptoms: You will likely not notice any drivability problems. Causes: A code P1451 may ...

inspection fail for MIL Commanded-On and P0455 on 2000 Dodge Stratus sedan. Why would you go to inspection, with a govt mandated check light on the dash ?? You had to know your PO455 was a Gross EVAP ...

I just had my emission test done and I failed the MIL Command Status. The Diagnostic Trouble Code is P1776 Manufacturer Specific Code. What does that mean? solenoid switch valve latched in lr position

2001 Ford Ranger 4 cylinder failed Emissions Test because MIL Commanded-ON failed. What do I do to repair or pass test? Engine RPM at Reading: 00950 so the mil is commanded on and yet you have no DTCs

I have a 1998 dodge Grand Caravan with codes P0700,P0734 & P0733. What does this mean? The motor is a 3.3 liter automatic transmission. The van is acting like it doesnt want to shift properly. Can

...When the temperature reaches about 223-degrees F (value depends on make/model/engine), the PCM will command the cooling fan relay to turn on the fan. It does so by supplying the ground to the relay. ...