...color. The starter may be getting hot, or if it comes against compression when the engine attempts to start, it will do it's job and go back in. How do I check the cam shaft sensor on a 2001 Grand
coil rail resistance values are within parameters.changed spark plugs, checked wiring ,plug connectors etc." no bus" read out on inst cluster . hooked scanner to obd 2 port and got a "no link" reading
...coil housing. During this repair, I noticed that the #2 spark plug was serverly fouled (blackened). Upon replacing all these parts, I started the vehicle and the miss seemed to be gone. However, the ...
...resistance. All fuses with 0.0 ohms. 12.0v supply to ingition module and ground is good. Crankshaft sensor with 200+ millivolt signal. Had excellent spark from coils, now none; have replace ignition ...
resistance; all in spec as is the crankshaft sensor signal (200+ mV). Good 12v supply and good ground to igntion module. I HAD a good spark, then none. Replaced the igniton coil module (twice, thought
...coil packs nearest the firewall. the CPS is located directly behind the crank shaft pulley. Heat saturation is what kills these solid state units. They work great cold and as heat creates resistance, ...
...2001-2005 L300/LW300 2004-2005 L-Series 2002-2008 VUE 1996-2002 SL/SL1/SL2 1996-2002 SC1/SC2 1996-2002 SW1/SW2 OK, back again, I THINK I got it remedied,,, I repositioned the TPS sensor just a hair ...
...coil connector. There should be infinite resistance. If there isn't, repair the short to ground in the coil driver circuit NOTE: If the ignition coil driver signal wire is not open or shorted to ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions