...chrysler concorde, 3.5 v6 24valve. i have a starting issue,my car was running fine then i left my house got a block away and my car stalled, and won't start.there is no spark in plugs 2 and 4, i had ...
...4 1/2 years ago, but since they don't drive over 40 mph, I am thinking it could be the convertor again. We don't have a Chrysler dealer in town, so, any ideas? I used to be a chev parts manager, but ...
Chrysler Sebring LXi v6 2.5L. Car had a hard time starting. It would turn over but not start. When it did start, it would run and idle fine for about 4 minutes and then die. I've recently replaced the
...Chrysler Sebring 2.5L V6 Convertable. It started stalling at intersections; would lose RPMs' and die while driving it; and would not start unless it sat for a few minutes. Once it started, you'd have ...
...Chrysler Town and Country 3.8 L V6. The sensor in question is behind the engine on the exhaust manifold. You can test the heater in the sensor with an ohmmeter using the following procedure: ...
...4 a 2004 chryslet seabring platium limited. V6 I use Castrol GTX 10w30 in all my cars all year long. I live in So. Calif. I've got a '92 Ford Ranger 3.0L V6 with 114,000 miles and hav'nt had a single ...
...chrysler sebring coupe with a 2.5 v6 engine.My problem is the car idles rough and misses at low rpm.But it runs good on the road no problems. When i let off the gas like going down a hill or going to ...
...Chrysler 300m. My code reader read that all 4 o2 sensors were bad (only this would happen to me at 1 time) so I replaced all 4 sensors and erased the stored codes drove the car about 20 miles and the ...
...Chrysler Minivan Fan ... https://www.chryslerminivan.net > threads > temperatur... Oct. 4, 2015 - Where should the temp gauge needle be at operating temp? 1/4 from bottom? ... 2002 Grand Caravan ES ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions