...gauge on 2006 Chevy runs at 80 then drops to 0 The truck runs fine. The oil level is full. Any ideas what is causing this to happen? Is it safe to drive? whats the gauge do when the truck is ...
...Chevy Silverado 1500 why did this happen and how do I fix it? it is either the oil sender or the cluster gone out. i have seen both with the factory scan tool you can do a gauge sweep test to see if ...
Chevy silverado.when I step on the gas my oil reaches 80psi,why is that Your oil pump is driven by the camshaft. When you step down on the gas, the engine (and of course the cam) turns faster, turning
chevy silverado 5.3L..When in idle oil pressure gauge goes to 80 and when i accelerate ail pressure goes to zero ...is it the oil sending unit? It could be the sending unit. If the truck is low on oil
Question about 2006 Silverado
2006 chevy 1500 silverado oil pressure gauge reading 80 how do I trouble shoot is this a problem if oil pressure is 80 when i start it up?
Chevy silverado v8, 2wd does not work. It reads 0 pressure and stays until at a stop and radically jumps. Sounds like you need to replace the oil pressure sending unit. Should be located on the engine
Question about 2006 Silverado 2500HD 2WD
2006 chevy 2500 with 6.0L Vortex where the oil pressure sender unit is on the block install a "t" fitting . Place the electrical unit in one side and a brass fitting in the other . Run the copper line
Question about 2006 Silverado 1500 2WD
...chevy silverado i have changed master cylinder and booster and rear brake shoes but pedal stills goes to the floor tried bleeding brakes but get no fluid to the front brakes only the the rear any ...
Question about Automatic Transmission And Engine Oil Pressure Tester
2006 chevy silverado clasic transmission wiring diagram 2006 chevy silverado clasic transmission wiring diagram
Question about Automatic Transmission And Engine Oil Pressure Tester
a 2006 chevy Silverado 4x4v8 6.0 vortex The oil pump is driven off the cam gear on the bottom of the dist. The pump just needs to pump and hold the correct oil pressure for the engine. Hope this helps
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions