Questions & Answers for: check starter cable connection 96

Question about 1997 Aurora

2 Answers

..."bumps" in the line. Check to be sure the connection to the starter is clean and tight. If all is good and it still will not start then remove you alternator and have it tested and repaired as ...

Ad

Question about 1999 Aurora

3 Answers

...it down to where /the component the other end of cable attaches to this will be the starter solenoid which is attached to the actual starter motor including trucks Bad news ... down inside the ...

Ad

Question about 1996 Aurora

1 Answer

...work in my 96 olds aurora Check the fuse then check the bulbs, and also check the brake light swithch under the steering collum along the brake peddle arm for bad connection or alignment. Good

...radio still may work. If you still have a problem, check the starter. It may be bad. If the car is on and when you go to start it and all you hear is a clicking noise, then its the starter. Good

...starter usually go bad on 96 olds aurora?mileage? ive seen them go from 50k to 110k you never know an actual its internal there is no set mileage for a starter to go bad, excessive cranking from ...

...starter relay connecters then it wouldn't turn over at all. It turns over and eventually starts, but takes a while to catch. Any ideas? maybe the fuel pressure regulator bleeding down while parked. ...

...check the size of the starter bolt/ remove battery terminal/ remove electrical wiring connection both positive and negative and body ground from ur starter/ loosen bolt with a wrench/ pull out old ...

be the starter, but make sure you are using a good pair of jumper cables, and they are making a good connection to each vehicle. Also check to see that your battery terminals are tight. Check this out

...THE TRANSMISSION NEUTRAL SAFETY SWITCH IF ITS BAD STARTER WONT WORK.ALSO CHECK THE THEFT DETERRENT MODULE RELAY. BEFORE REMOVING BATTERY CABLES TURN OFF RADIO SO YOU WONT LOSE YOUR RADIO PLAYING

...96 Olds Aurora Is there an emergency fuel shutoff switch in a 96 Olds Aurora. I cant seem to get the FP relay to click and the FP will not run. Only Ford products have inertia switches. The relay is ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...