Questions & Answers for: changing rear directional tail light

rear tail light (on the trunk) is not working. How do I remove & replace the bulb? I remove back cover by pulling directly (straight) down.......It has no screws, that was what was a little confusing.

...rear of trunk, remove it and place it out of the way, remove tail light Assembly retaining nuts top and bottom, I think there are 6 per side, pull the tail light assembly straight back to access the ...

...tail light? I want to change the tail light bulb on my 2006 Mustang GT. I unscrewed the two wing nuts that hold a plastic panel that covers all the light wires. But, there are a couple of plastic ...

...and I don't have the owner's manual. What do you think the problem could be? All the fuses are fine and so are the relays. first check rear tail light bulbs, fuse and then have light switch ...

...tail light (on the right side) lights up I'm not getting power to one wire on the right rear brake/turn light. I have replaced the bulbs with no luck... Check fuses at dash panel as well as any under ...

changing bulb for rear brake light All you need to do is open the tail light, once opened you can see the bulb light holder, you need to twist towards the open direction shown on the holder, replace ...

rear tail light on 2006 honda odyssey Lift the rear door, remove the rear tail light lense, replace the bulb and replace the tail light on the car.... once the screws have been removed, be sure all of

...rear side of the car (directly on the unpainted body). Now my tail and park lamps keep shorting out even after the ground was removed! The fuse will blow after about 3 seconds of power and ...

rear running lights working. The headlights, brake lights, directional and emergency flashers all work. Have changed out the light switch assembly and checked the fuse also. Still no running lights or

2006 ford mustang side marker lights do not work All of my side marker lights front and rear dont work I have never heard this complaint on this generation of Mustang. I can direct you to the wiring ...