Questions & Answers for: brake pedal tight

...brake pedal goes to the floor board Two persons are required: one to bleed and other to press brake pedal. Remove wheel and hub of the side you want to bleed. You will find the bleed nut there. Open ...

...brake pedal. Very common problem. at your brake pedal is a brake light switch that could be stuck or just bad. make sure the brake pedal is tightly bolted to the fire wall and the switch is being ...

...Brake pedal is tight and making strange noise I dont know what a TIGHT brake pedal is, but if its hard to push and hard, then the brake booster is bad, OR the hose to the booster is bad OR the engine ...

...brake pedal then you probably have air in the brake lines from the last brake pad replacement. The brakes need to be bled with this method: Use 1/8 inch 2 foot long hose from parts store and attach ...

...brake pedal firmly for 4 - 5 times to the floor, and maintain the brake pedal pushed to the floor. 5. Begin with the rear right wheel. Another person remove the dust cap and loose the brake caliper ...

...brake pedal is tight After driving the vehicle and braking a short time all four wheels lock up and the brake pedal is tight. I then raised the vehicle to check and make sure that all wheels were ...

brake pedal to the floor, the truck should not move freely when the accelerator pedal is depressed. The emergency brake assemblies on both rear wheels are connected to a cable assembly that ultimately

...brake pedal? kangaroo hopping and shuddering to stop when I try to get out of tight car park.I may have foot hovering/pressing foot brake. Hello again, Please note that the Smart car is equipped with ...

...brake pedal gets tight or does the brakes get tight and slow vehicle down as if brakes are being applied.....If it is just the pedal getting tight and hard you have a vacuum Brake Power booster ...

...brake pedal not releasing. When turning and brakes tapped briefly they continue to brake until complete stop. When stopped and foot off brake 10 sec delay before pedal releases Master cylinder ...