blower motor only works on hig this is caused by a defective blower motor speed control resistor, it is located near the blower motor in the air duct the blower fits into. here is a piture of the part
...blower motor resistor if the fan only blows on one speed. It is located underneath the firewall on the outside, near where the passenger exhaust system is. You need to take the passenger side cat ...
where is the blower motor resistor found on an 2003 grand marquis on the left of the heater core
...electrical on motor and it's OK. What else can I check? check the blower motor resistor- located next to the blower motor- or check the fuses. what do it look like and can I take a meter and test ...
...blower motor blows normal then slows down 1999 grand marquis There is a blower resister within the blower fan that is replacable. Most likely this is the problem If blower motor works on all speeds, ...
...blower motor electrical connector. Remove the hose. Remove the screws and remove the blower motor. CAUTION Clean any corrosion from the blower motor shaft before removing the fan. Remove the wheel ...
...blower motor speed control resistor, the resistor is located near the blower motor. You need to replace the blower motor resistor. That is what is bad, only allowing the fan to operate on
blower motor does not work there is no voltage at blower motor plug checked fuse already and that is good and checked the relay they were both good voltage comes from the actual a/c head,chek a wiring
...blower switch is a 4 speed. the first two LOW, and next position are not working. Is the switch module or the fan motor in the engine compartment? There are resisters that controle the fan ...
Question about 2003 Grand Marquis
2003 Mercury Grand Marquis temperature control sensor location were is the blower motor temperature control resistor located its locate under the hood at the front of the car on the driver side.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions