Questions & Answers for: bat jumper

...bat automatically starts the program for BIOS flashing. But... 4.The message is appear: "A:\>flash840 6bx7p.f5 DOS/4G Protected mode Run-time Version 2.01a Copiright... Error 30 - Flash part isn't ...

...bat. will start with a push. guage looks good too while running. there should be a sloenoid on the firewall it could be bad These were not made with a safety switch on the clutch, but far as the ...

i have a 1965 ford thunderbird and the switch is busted cant get fire to the points or the plugs put a jumper wire from the pos on the bat to the pos on the coil.

...only the dear can disabe it but if you run a jumper wire from your bat to the coil and a jumper wire to back feed the accessory lines and then run a line from starter to start the car it might run

batter seem ok but only hear a clicking sound when I try to start it even with jumper cables. clean bat posts and cables real good and check for loose connections

...jumper or new bat, click click nada, all other electricals on. happened once before years ago, think i replaced one of three silver relay/capaciter in fuse box which solved problem. Any suggestions ...

...bat you should disconnect the battery before it's drained, then find the connecting wires for the siren/horn and disconnect them (reconnect the battery) so that you can make the trip to the dealer ...

...jumper. is battery my only problem?? While running use a vom should read at bat 13.7 or so,, when off,,, bat should read 12.6 if bat 4 years old replace or if not kept on smart charger w/ not in use ...

...bat out and unplugged all cords on inside and re-plugged them. got system code, but still need bios admin code is there anyway to bypass this Look on the motherboard for 3 gold pins in a row, and a ...

06 king quad. bat. was dead i went to jump off. bat. leads were both red. hooked up jumpers backward. arced unhooked. battery tests ok. but no power to ignition & display. fuses look ok. won't crank. ...