Questions & Answers for: audi a3 2004 starting

Audi A3 2001 fan running all of the time, Temp guage not moving from start position and EML on? already replaced Coolant temp sensor? Any ideas? ON ALL A4 MODELS AND I THINK THE A3 , THE ENGINE ...

audi a3 2004 reg and yesterday the petrol light came on due to lack of petrol and i tried to start the car outside the house which did start after a number of turns so i drove to the petrol station to

...AUDI A3 sportback, model 2004, TDI (tip 8P/LBKCF/A3) with 55,000.KM. For the past 2 months I encounted the following problem: the first start in the morning is O.K. and smoothly.During the same day , ...

Audi A3, 3.2 Quattro) Are there known causes of a rattle that has just started and has got a lot worse? It's at the rear of the car on the driver's side and is definitely not something inside the car

...audi a3 2.0 tdi 2004 has a problem like this when the engine starts turns the fans and increases from 900 to 1100 pm when the fans stop the rpm goes down even when the engine is cold the fans ...

...Audi a3 1.8t sport relay switch for coolant fan. Haven't heard of a relay switch for coolant fan. You must be talking about thermoswitch which starts your coolant fan when coolant reaches a ...

...audi a3 2.0 tdi has cut out and wont start seems like it is turning over really easy it has done 66k and was no funny noises there is no warning lights or anything. All warning lights work, car will ...

...audi a3 2.0 TDI would the engine position sensor coz the turbo not to kick in properly? NO THE PROBABLE CAUSE IS A VALVE THAT ADJUSTS THE TURBO PRESSURE!CHECK FOR DTCS FIRST AND LET ME KNOW!! Morning ...

...Audi A3 2.0 fsi. Loss of power when driving. Engine is hot. Misfires and stalls. Starts up again after a few minutes. Just replaced oil filter housing and since then have had this issue. sounds like ...

...audi a3 ran beautifully before, now struggling to start and sounds rough at low speed (upto 40mph). Any ideas? it sounds like you should have hired a pro to do it. i hope you didnt bend any valves. ...