Questions & Answers for: asus wl520g reset factory

Asus WL-520GC cant configure hi all, my problem is: when i go to configure the router give me this error : EZstup cannot be used while bridge function is enable. and i cant enter in the router enter ...

...ASUS 520 ROUTER OK, I CANNOT REMEMBER THE PASSWORD TO CONNECT TO CONNECT MY NOTEBOOK Your router can be reset by looking for a pin hole or some reset button then while plugged in press the button for ...

...paper-clip. Put the straightend end into the small hole in the back of the router, to reset it to "factory" settings. Then, rerun the "Setup Wizard" (wired and wireless) to rebuild your

reset/reconfigure the router. Have you done router setups before? If not, I suggest you get someone to help you. If you want to try anyway, then have the printed manual next to you as you step through

reset my asus router I had same problem with my asus device. so i called Asus Tech Support At Toll Free Number 1800-585-2494 and they have fixed my problem. Hope they will help you as well. You should

factory settings. This means you will lose all of the changes you made since you got the router. Make sure to write down any things you've changed, so you can change them back after the reset. Also, I

...unplugging the router and plugging it back in. wait 5 seconds after plugging back in and release the reset button. The router should be back to factory default, with no password. Hope this

...asus rt-n12 wireless n router In order to get your router back to the original settings, you must push in the reset button (usually on the back of the router) for somewhere between 10 and 30 seconds ...

reset to factory settings. ( dhcp is usually enabled by default) the lights for network activity should blink for a few seconds as the router gets a new ip from the network. you should then be able to