...water log again, which may takes as few as 10 minutes in the pool. 2. Stop using all those words *********** didn't teach you and probably didn't even know...This is a common problem. ...
Question about Turbo T2 In - Ground Pool Cleaner
...aquabot-turbo-t2-manual.pdf According to the trouble shooting guide: Pumps Water, but Does Not Move or Moves Slowly 1. Remove any foreign matter that may be obstructing Drive Tracks. 2. Check Drive ...
...water and acts fine its tracks even move but the second that it touches the floor of the pool it stops rotating and scoots a little and stops with his jet stream still working and coming out. i ...
Question about In - Ground Robotic Pool Cleaner
...aquabot-automatic-pool-cleaner.com/ Shelby Christian [email protected] Check the handle for water inside, common problem. Make sure no air is in the system. Remove all floats if installed inside the ...
...in the drive system is worn, allowing the belts to skip. There is a good guide at http://www.aquabots.com/repair-instructions/drive-belt-replacement.htm and it could just be the belts. Also, ...
Aquabot Turbo T2 flips over when it tries to climb walls. Water is not coming out the top but the unit is moving fine. Does it need a new pump motor or can something just be clogged inside?? the ...
troubleshoot aquabot turbo won't pump water moves slow bad pump motor possible bad drive motor also
Question about In - Ground Robotic Pool Cleaner
Aquabot wont pump water or move, worked yesterday sounds like a circuit board failure
Question about Turbo Robotic Pool Cleaner
...aquabot turbo will not move or pump water? My unit will not move or pump water. The fuse is good. When I turn the unit on and push the reset, there is a humming. Probably the drive belt came off the ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions