Questions & Answers for: Hayward aqua air

aqua critter why did my new aqua critter stop working after 5 minute Remove the center inlet port and check for some sort of blockage in the intake jamming the drive paddle.

aqua rite chlorine generator is powering down about 5 seconds after turning it on. This just started happening after 8 months. If its still under warrenty, call hayward asap

SALT LEVEL READING IS WRONG Clean all anode and electrode in light acid solution and replace sensors.

looking for instruction manual Here is a copy of the users manual for the Aqua Bug pool cleaners. Hope this helps. http://www.backyardcitypools.com/Images/Hayward/Aquabug-Manual.pdf

Hayward aqua pod says freeze warning possible bad temp sensor

hayward aqua plus control unit error code senor short bad temp sensor

...aqua critter. If i unhook the critter the pump re-primes. Any sugguestions as to why? Your hose either has a hole in it, at the sections at the waters surface where it is exposed to the air? Even a ...

my readout says check pool bridge comm. ???????? lost communication turn all off then control on then heater

hayward h400ped2 not turning on by aqua logic control I can turn the heater on manually but not by remote I can't determine if the aqua logic is not sending a signal to the heater or the heater is not

HAYWARD Aqua Rite impossible do diagnostic i find the aqua rite systems to be very helpful in diagnosing problems. if you can describe the problem you are having, i may be able to help