Hayward aqua pod says freeze warning - Hayward Pool & Spa

there is a relay on the back of the main circuit board that has separated from the circuit. you can resolder this relay quite easily by removing the board.
DANGER: be sure to cut the power to the control box at the main breaker. turning off the breakers in the hayward box will NOT eliminate the power

the VSP error is a code from the pump and not the controller or control system. the only way to clear this is to turn the breaker for the pump off for about 30 seconds to allow the electronics to reset.

Check bateries on control panel. Next check the relay. Batteries in hand held too.

go into set up menu and reset it

what type the heater is communicating to aqualogic control is RAYPAK digital 2100 ? also go to outside where the aqualogic control is and look for diagnostic in control look for water temperature sensor connecedt to aqualogic and see what that say,

Why is our Hayward system is saying clorinater turn off high temp

You will need two temp sensors, one for water(two wires) and one for air(the other two wires). Look at the board and you should be able to see it labeled.