Questions & Answers for: amp water pump 1997 dodge

...1997 dodge dakota when I try putting gas into my truck, the pump clicks as if I had a full tank. is the gas vent tube easy to change or check to see if its blocked? 1997 dodge dakota 5.2 V8 automatic ...

...water pump and the belt. THe vehicle had previously always been nice and quiet! Thanks Guys! if it sounds in belt area install a belt from the dodge dealer, had this problem several times and always ...

...water pump on a 1997 Dodge Dakota 6cyl 3.9liter w/ air? 1. Drain the cooling system. 2. Remove or disconnect the following: * Negative battery cable * Fan and clutch assembly from the pump * Fan ...

...water pump to remove the fan and replace the waterpump. on 1997 dodge dakota. 6cyl. thanx Tony. the fan nut is part of the fan,you need to unscrew the nut from the water pump to remove fan,this is ...

...1997 dodge dakota 4cly 2.5 liter just put a new fuel pump in, and it doesn't work I have power to pin 1/dark green/black. I have ground to pin 3 black/light blue strip. I have ground to pin 4 black ...

water pump bypass hose I need to find the quickest most accurate way I was looking for the same answer / solution, I ran a search for a Dodge Durango and nothing came up. I reran the same search for a

...water pump on my 1997 dodge dakota? Use a long screwdriver to pry between 2 of the bolts while you loosen another bolt with a box-end wrench. Don't take any bolts out until you have them all loose. ...

...is the fuel pump located on a 1997 dodge dakota The fuel pump is located inside the gas tank, the gas tank must be removed to replace the fuel pump, just did mine, about three hours and $200 in

...amp; clutch. Im putting a new water pump on now. if i still have noise what other things should i check. Alternator, A/C Compressor, Power-steering pump, smog pump, idler pully(s). I would pull the ...

...pump from my 1997 dodge dakota. How is that possible ? You make a statement ,but do not ask a question or provide any discription of what your doing & why the removal of a few bolts would be a ...