Questions & Answers for: acura rear brake pad replacement

...Acura MDX 1. I am considering replacing the front and rear brake pads (and rotors) and found a torque recommendation of 20 ft/lbs. for tightening the calipers. This seems low to me. Is 20 ft/lbs ...

Acura dealer just told me I need new rear brakes and rotors on my 2005 TSX. There is only 23K miles on the car. I trust the service dept., as I've been going there for years. 23K seems low to me for a

...rear brake hardware kit, parts should be about $120 so that means $155 for labor when the job would only take about an hour at the most. I was quoted $325 for the fronts and $275 for the rears at my ...

Do you know what type of brake fluid is used on a 2006 Acura 3.2 TL? Need to replace rear brake pads and rotors and need to make sure the correct brake fluid is used. Thanks! dot 3 brake fluid

...brake pads frony and rear on 1997 accura cl 3.0 This is not easy. Look at the Cl brake blog by P48. You can get the rear caliper piston in the fully retracted position with a home-made tool to twist ...

...rear-brake.html--------2008 Toyota Tundra: Brake Rotors and Wheel Bearing Replacing? http://howtobyme.blogspot.in/2012/04/2008-toyota-tundra-brake-rotors-and.html----------2008 Toyota Tacoma: ABS ...

...rear and the disks on the front. It can be issue with master cylinder or the problem is there is still some air there in the system that has to be bleed. Or else the parts replaced are not aligned ...

...rear brake gradually froze up. Will go reverse but completely frozen forward. Messing with the footbrake has not produced results. brake light is on. Is this a drum/brake problem or a parking bra ...

...rear brake pad The only way to fix brake pads is to replace them as a set (both sides at the same time). If the discs are scored or damaged either turn or replace them. Check that the caliper slides ...

...acura integra GS. Hi. Your adjustment on rear brake indside rotor if off on one side. Pool both rotors out and you will see the distances in between the hand brake pads are different. Masure it and ...