brake light and abs light on dash stays on. even after they were bled they would bottom out on second hit and there,s no brakes. try to flush all the brake system if its stay same u have to change the
...ABS light came on and the traction control showed off and wouldnt change then steering and braking became difficult then car wont start. It will turn on like the battery may be okay but wont crank ...
...For proper fluid level, If level is good Try changing the trans filter Check your sensor. My ABS light has been on and I took a look underneath and found out that my brake sensor was loose. Easy
...abs and brake light comes on and traction control don't work I just recently had that problem on one of our '03 Crown Vics and we had to change out the wiring. First, I took off the panels below the ...
...abs and brake light turn on some times,later they turn on constantly after the car starts and get the normal temperature,yesterday I changed the abs module and the brake light dissapear but the abs ...
...abs and brake light stays on i dont know what to do please help. the abs has a on board computer that runs the system. it checks itself every time you start the vehicle. when its operating normally, ...
abs and brake light on changed all 4 wheel sensors,cleaned all connections,took plug off abs module and cleaned. you need to have the code pulled to find out what the problem is.so far you have spent ...
Question about 2007 Crown Victoria
...ABS light, brake light, and fire suppression system lights illuminated. My AutoEnginuty scanner shows a U1900 code and can not communicate with the ABS module or the fire suppression system module. ...
Question about 2006 Crown Victoria
...crown vic code b1596 abs and brake lights are on J'ai deux codes Ford ranger 2010 code b1596 et c1145 chang? sensor de vitesse effac? de nouveau et les lumi?re abs et traction control rallume que ...
Question about 2002 Crown Victoria
Antli lock brakes kicking in as coming to a stop at low speeds and no abs light Clean wheel speed sensors, metal from break dust collects on the magnetic side of the sensor.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions