...5S-FE 2.2L motor. Hopefully this helps.....http://www.turboninjas.com/camry/eg1.pdf when your cranking your engine by hand on the crankshaft bolt you can hear a breathing sound on every stroke of the ...
...5s-fe. with the timing belt on the vehicle install the botton piece of the timing cover with crank pulley. line up the notch on the crank pulley with 0 on the timing cover for top dead center on the ...
what is the correct valve timing marks when installing cams in a 5s-fe 98 celica GT check the marks at the camshaft pullies.
...FE and 5S-FE Engines Remove the timing belt covers as previously detailed. Raise the engine just enough to remove the weight from the engine mount on the right side. Remove the thru-bolt, two nuts, ...
...5S-FE Engine Drain the engine coolant. Remove the timing belt. Remove the No. 1 idler pulley and tension spring. Remove the No. 2 idler pulley. Disconnect the lower radiator hose at the water inlet. ...
...FE and 5S-FE Engines When install, align the crankshaft pulley set key with the pulley key groove. Install the pulley. Tighten the pulley bolt to 80 ft. lbs. (108 Nm). On 2S-ELC engines, turn the ...
5S-FE Engines Remove the timing belt covers as previously detailed. Raise the engine just enough to remove the weight from the engine mount on the right side. Remove the thru-bolt, two nuts, and right
Question about 1997 Celica
...FE and 5S-FE Engines, but pay attention at this...To install:Align the cutouts of the oil pump pulley and shaft, and slide the pulley on. Retain the pulley while tightening the nut to 21 ft. lbs. (28 ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions