...my Altima my Right back turn signal and break light is on the same bulb. The signal works but the brake light doesn't work. Very odd. replace the bulb. it has 2 elements and one of them is burned
...2009 Nissan Altima? I'm looking to obtain a 2nd key fob/transmitter for my 2009 Nissan Altima, but do not know how to program it correctly. I'm trying to avoid paying a Nissan dealer > $100 to ...
...nissan altima, overheated and no leaks after fluid replinished, but car will start and then shut off after a few minutes. check to see if your engine oil and antifreeze are mixing.if overheated you ...
...2009 Nissan Altima? first you need to remove the clip that holds the trunk liner, then you'll have to pop off two white electrical connectors on 8mm bolts. Remove them using 8mm ratchet socket ...
I have a 2009 Nissan Altima the blinkers flash on the dash but not at all on the exterior check your fuses. The fuse for the signal lights might've blown
2009 nissan altima brake light is out, but the blinker works, its the same bulb, now what get a new bulb. the bulb has two elements in it brake light element is most likely burned out you do not use ...
2009 altima. I hearing a roaring noise In my 2005 Nissan Altima I experienced a roaring noise from the rear of the car. It ended up being the rear wheel bearings needed to be replaced. It appears that
how to change rear brakes on 2009 nissan altima May need spacial tool to back up piston.two bolts holds caliper could be 13 or 14mmm.
Question about 2009 Altima 2.5 S
2009 Nissan Altima 2.5s? A picture or diagram most needed the back of engine (the side facing rear of car) thanks Hi! Please refer to the following link! You will find ANYTHING you want there, I guess
NISSAN ALTIMA Summary. ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR. Remedy.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions