1998 GMC K2500 pick up 5.7 liter Long story short, it just keeps turning over but will not start. I put in a new gas tank, fuel pump, changed plugs/wires/cap and rotor. I know the engines getting gas,
1998 GMC sierra, I Have replaced the heads, timing chain, done a tune up, also I replaced the crank sensor, on the advice of someone else and STILL it shows this code. Ran a test of the cam sensor got
...Gmc sierra 4.3 I think I crossed one need distributor diagram ...
...1998 GMC Sierra? The timing is not adjustable and it is computer controlled, but the distributor must still be clocked in properly and static timed, and here is how it is done. There is a mark or ...
1998 gmc pick up with 5.0 engine, do I have to mark anything or just take off bolt and pull out. You need to mark in 2 places. With the cap off mark the position of the rotor button on the distributor
...GMC 350 the firing order is 1-8-4-3-6-5-7-2. The distributor rotor turns clockwise when viewed from above, so the spark plug wires would be installed in the same order as the firing order, beginning ...
...gmc la sierra 1500 5.7 vortec ano 1997 le acavo de reparar el motor pero no la puedo poner a tiempo Clean off the crankshaft pulley at the front of the engine and put some paint on the timing marks. ...
...1998 GMC Jimmy 4.3 4x4 Mice ate the wire going to the cam shaft sensor, I removed the distributor shaft but did not have the right torgue bit to remove distributor cap first. Replaced did not start. ...
...distributor out to replace intake gasket the timing marks are on the timing cover housing at the top of the crankshaft or just slightly to the right . They are a series of raised marks going from TDC ...
Question about 1996 Jimmy
...gmc Sonoma 4.3 vortex sls and had to set timing it will start but want run longer than 5 seconds what do you think? James did you replace the timing chain or have the distributor out? If you had the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions