Questions & Answers for: 1998 ford truck drive cycle

Question about 1998 Contour

3 Answers

...drive or reverse it takes it around 3/4 secs before it catches or when getting on higjway it takes it a min. to shift on through it's cycle like it slips a little. it is an automatic bad transmission ...

Ad

Question about 1998 F150 Regular Cab

1 Answer

...1998 f150 4x4 4.6 tow package. Just started driving this truck. Driving down the highway on a 75-85 degree day w/ ~3500 lbs behind it on a trailer. The clutch is turning the fan on every half mile or ...

Ad

Question about 1998 F150 Regular Cab

2 Answers

...1998 ford f150? You have to drive the vehicle after the codes have been reset to let the monitors do their tests....If every test ok it will pass inspection....Its usually about 75 miles..... Here is ...

Question about 1998 F150 Regular Cab

1 Answer

...1998 Ford F150 Drive cycle - how many miles ? I need to get an emissions test, and I recently disconnected the battery so the computer "was not ready" yesterday IT IS NOT A CERTAIN NUMBER OF MILES ...

service engine soon, light is on even though the problem has been fixed. how do I get the light to turn off Remove the negative battery clamp from the battery for a few minutes, if the problem has ...

Question about 1998 Ranger

1 Answer

...in. you take the screws out un plug it put the new one on and your done. the check engine light will not turn off until you drive it awhile your "drive cycle" may take up to a hundred

I took my car to do the state inspection and i was told my emission sensors are not ready , evap, obd2, oxygen etc. There were no codes present , and i was told to drive it and come back , after i ...

Question about 1998 Ranger SuperCab

1 Answer

...truck has not been driven enough since the battery was disconnected or the codes were cleared to have a new history. The cycle drive needs to include about 50-100 miles of both city and highway ...

...1998 ford windstar? codes are po133 and p1000 A code P0133 may mean that one or more of the following has happened: The oxygen sensor is faulty The wiring to the sensor is broken / frayed There is an ...

Question about 1998 Ranger

1 Answer

1998 Ford Ranger runs rough. I replaced the motor and computer, runs rough but idles. If I give it gas it revs up but as soon as I let of the gas pedal, it cuts off like it's idled too low, maybe TPS?

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...