Questions & Answers for: 1994 skylark

tension belt pulley needs to be replaced. I have the new pulley and serpentine wrench, but can't get at the tensioner on my 1994 buick skylark 3.1 have you tried going through the fender well?

I need to know how to change the starter in a 1994 Buick Skylark The car will not start it just clicks when you turn the key check your battery.

...1994 Buick Skylark to drain radiator?? I have a 1994 Buick Skylark..it overheats...cracked head gasket I think. So I put stop leak in it today and can't figure out where the valve is to open the ...

replace alternator 1994 Buick Skylark Can't find tension pulley on 1994 Buick Skylark. what side is for losse the screw in the crank pulley in the buick 2.4l?

Where is the starter for a 1994 Buick Skylark with a 3.1 motor located? Either right on the front of the engine or on the back under the exhaust manifold

1994 buick skylark has hesitation promblems sounds... my buick skylark grand sport has the same promblem i checked spark plugs and wires they seemed just fine. could it possibly be the fuel injectors ...

1994 Buick skylark. we have tried two different keys and the ignition switch will not budge. try pulling the steering wheel to to one side or the other while turning the key some times the collum lock

where buick 1994 skylark fan relay located where buick 1994 skylark fan relay located in the right hand rear of engine compartment behind strut tower

1994 Buick skylark turn signals are not working. The turn signals on my 1994 Buick Skylark were working for a while but were speratic. They would blink almost normal when I messed with the switch ...

...1994 buick skylark not running on all cylinders and blowing smoke Do a cylinder Leak Down Test-dry,then repeat wet Injectors may be dirty & need to be mailed away for cleaning, they could be ...