Questions & Answers for: 10 table induction motor

...table saw The motor sounds like it speeds up and then down, there is quite a lot of movement up and down, I really like the saw but am afraid to use it in this condition I bought it in 2002 can you ...

...table saw for 5 years now it's a great saw. I'ts a Delta 5 h/p left tilt. I bought it just before the x-5's came out. Anyway I'm a wood worker not a mechanic. With that being said the motor for some ...

...table saw stops after a minute or two i replaces the capacitor and still does the same the breaker pops out This means it's drawing high amp. Could be just packed with saw dust, getting hot. The ...

...10" table saw starts a low rpm and does not go into high rpm - after a a few seconds it fails the circuit breaker, and without the belt conected this does not happen. Is the motor fryed? This saw ...

...10 minutes against a quartz clock. ALSO do a voltage check with another voltmeter. The 5500 Watt generator should hold 40 amps. Power tools with induction motors like some table saws take a large ...

...induction motors and the centrifugal assembly you mention is used to give the motor extra power on start up once running its not used you should test the capacitor is ok. it could be the motor ...

...table saw with nothing special about the light switch.  But if you have a 1 hp or larger motor use a high current rated switch, perhaps you can find a 20Amp switch.  The make and break arc ...

...10" table saw? I have a need for 3/4" dado stack blade use, but the arbor is out of threads above 5/8" dado width. Looking at the picture of the saw it appears virtually identical to many others ...