HIGH AIR END TEMPRETURE. MODEL M-40 - Ingersoll Rand Rotary Screw Compressor 230 Volts Single Phase 5 HP 185 CFM

If you can pull the work load guide it may give a clue to why the unit is overheating. Not all air compressors are designed to run specific tools. For a better understanding what tools are you trying to run?

Nominal tempreture for your refrigerator is 36-38. on the Freezer the tmpreture should be between 0-2. One of the first things to check is on the freezer side is there any frost or snow build up on the rear wall of the freezer. If there were this is termed as a defrost issue. If you do have this issue with frost build up message me back and I will instruct you how to repair this issue. Another thing to check is if the evaporator fan inside the freezer is blowing the cold air into the refrigerator. The Freezer section is the only area that produces the cold tempreture a fan blows the cold air off the evaporator coils through a damper door that opens and closes depending on the tempreture the refrigerator side is set to. Also check the damper door for any ice build up as well this would cause the door not to open and close and remain in a stuck postion. This would cause inadequate tempreture in the refrigerator side as well. If you have any questions or need any schematics or step by step instructions message me back the model number of your unit and I will provide these and answer any further questions you may have. I await your reply
Thank you
Rick

Hi, Toyota have recalled its 2001-2003 Rav4s I own 2 of them and my 2002 had the same problem until I call Toyota National customer service and confirmed that my VIN# fail in the recalled vehicle. the main problem is ECM and replaced by local Toyota dealer free of charge. You need to act now by next year this warranty will end since your vehicle will turn 10 years. The other thing is it got to be under 150,000 miles on it. Call the Toyota National customer service right away.

check for the tempreture adjustment knob in the refrigerator section as it might accidently have been turn to extreme high ...setting the refrigerator tempreture to very low can cause this problem in the frezer section try turning the knob to medium or tempreture according to the outside tempreture....

try setting your refrigerator to a medium tempreture as it's getting cold so it will be good if you set it between low and medium somewhere you need to change the tempreture setting according to the cliamate even if the refrigerator is frost free .well it certainly does not mean that there will be no frost formation even if you keep it operational at high cooling inside

It is heat roller abnormally high tempreture.The fusing tempreture iisess above 240 degrees.

I have seen Garland's have issues with the pilot light. see if you can watch the cycle.It may takes several minutes. I have seen where the pilot actually lifts off the pilot assembly and go out and cause oven to fail. Turning off and on resets the failure and sometimes it will light. Start there and be patient.

Your refrigerant system is restricted and or the compressor is bad.

suspect outside tempreture sensor is disconnected.

is your vehicle automat climate control ?
suspect the tempreture sensor in the vehicle is defective and is not giving a true reading of the relationship between the set tempreture and the true air tempreture.