My ricoh machin mp2510 is showing 546 code how to solve this problem

Ricoh Aficio MP2510, 3010 Error code sc542 on Lanier ...

? 6:08
https://www.youtube.com/watch?v=58MQVyjfDyg
Sep 3, 2013 - Uploaded by Used .Copier
Are you getting Error Code sc542 on your Ricoh, Lanier,Savin or Gestetner copiers? ... Ricoh Aficio 1022 ...

How to reset Ricoh Error Code sc542 sc546 sc548 problem ...

? 2:41
https://www.youtube.com/watch?v=3CnGl1Ytp34
Sep 21, 2015 - Uploaded by Copier Liquidation Center
How to reset Ricoh Error Code sc542 sc546 sc548 problem ...Ricoh Aficio copiers : AFICIO 1013 F

Most likely photoconductor is bad and needs to be replace you can buy them on eBay sometimes check internet

"Unstable Fusing Temperature" Chang Fusing Thermistor.

SC541 is a fuser heat failure. This means the fuser, which heats up and fuses the toner onto the paper, is not heating properly. Most of the time on Ricoh's this is caused by failure of the thermistor(s) which are responsible for reading the temperature of the fuser unit.
I would look in your local phonebook's yellow pages under copier service/supplies. Either find an independent servicer, such as someone listed as "services all makes and models" or look for a Ricoh, Gestetner or Savin dealer. The Gestetner and Savin makes are exactly the same as Ricoh so they may be able to help.
Good Luck and Thank You for using Fixya.

SC545 and SC 546 are fuser temperatyre error. pls. check thetmistor/ thermostats, connectors if thernistor are deffective replace thermistors. after replacement or checking of this parts do the SC reset. 107 # turn off copier then on after 5 sec.

Error Code SC 546 is for fusing & SC 960 is for Current leakage, If u getting it regurally , change the thermistors for error code 546, & for error 960 change drum & charge roller.

Hello sir; Your machine need to reset, the procedure as follow;
1, press "clear mode", "107", then hold down "clear/stop" key, until screen change message to sp mode.
2, turn power off and back on ,machine will in working condition.

problema ricoh aficio 1022 copia en blanco aparece codigo
sc 193

Fuser installation error. Fusing unit set error. Remove the fusing unit out of the machine and reinsert it. It isn't seated in there properly. Once you do that the error code will go away.