Where do I find the download for my camcorder for windows 7: PowerCinema NE for Everio

Download and install Media Player Codec Pack 3.9.6.

Hi, You can download this ftware from this link
http://powercinema-ne-for-everio.software.informer.com/download/

Cheers! Thanks! Sandy

i think it not support or may be files is corrupted. check with other systems. also reinstall the software with same path

merry christmas

Try this

http://powercinema-ne-for-everio.software.informer.com/download/

Problem solved. I was thinking I could delete from the PowerCinema NE for Everio software program that comes with the camera but that is not the case, so it was just a matter of finding where all the video files were stored on the computer itself, ie, "myworks, Everio backup", and delete from there.

you can down load it at: http//www2.cli.co.jp/products/ne/update

The software iVerio might help you. It transfers and converts automatically all your videos from your HDD camcorder.

Have a look on the site http://www.convertmod.com

Hi, did you try downloading your videos through the included software? It should work best using the included PowerCinema NE for Everio. If you are using windows Vista, then you need to download a patch. Here is the link: http://www2.cli.co.jp/products/ne/update_everioM7SD/pcm4e_update.htm
Make sure you have PowerCinema NE for Everio installed before applying the patch. After this, follow a few simple steps. Turn off your camcorder. Connect the USB cable to the computer then to the camcorder. Then, turn it on. The software should load automatically, and using that you should be able to download the files. You might need administrator rights for this.

Hope this helps,
Eric

Have a look on the site http://www.convertmod.com, you will find your happiness with this wonderfull software that converts .mod files and that converts .tod files

It is easier to connect your camcorder through the included "PowerCinema NE for Everio". First (since you're running Vista), you have to download a patch. Here is the address: http://www2.cli.co.jp/products/ne/update_everioM7SD/pcm4e_update.htm
Note: Only after you have installed PowerCinema NE for Everio can you install the patch. After you have installed the patch, just connect your MG130 to your computer through the included USB cable. Then the software should run automatically.
Hope this Helps

Eric