Locate the evaporator canister on 2003 honda odyessey

It's on the A/C line between the compressor and the evaporator. They cost anywhere from Ten to Twenty Five Bucks. I hope this helps. Take care. If you have more questions for Me or just want to say Hi! Use testimonial. Thanks

Hi, your vechicle has whats called a "vss"sensor. I.e. a vechicle speed sensor. Usually down on the tranmission,its what gives the ecm its info. I would check that. Hope that helps.

Dirt and dust intrusion into the EVAP canister vent hose assembly, resulting in restricted air flow, may cause this condition.

Error Code: P 0443
Description:
Evaporative Emission (EVAP) Canister Purge Valve - Circuit Malfunction
Problem Area:
Wiring, or VSV connector loose or detached.
Evaporative emission (EVAP) canister purge valve.

Error Code: P0441
Fault Area:
Evaporative Emission (EVAP) System - Incorrect Flow Detected
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
- Evaporative Emission (EVAP) Canister Purge Solenoid Valve faulty/jammed.
- Evaporative Emission (EVAP) Canister Sealing faulty.
- Pipes between Tank Breathing and Throttle Body leaky/blocked.
- Hose connection(s).
Intake leak.
Solutions:
- Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
- Perform Output Test.
- Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve.
- Check Evaporative Emission (EVAP) Canister.
- Perform Basic Setting.
- Check Pipes between Tank Breathing and Throttle Body.

Error Code: P0440
Fault Location:
Evaporative Emission (EVAP) System - Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Soution:
Check Evaporative Emission (EVAP) System Sealing.
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .

Error Code: P0441
Fault Location:
Evaporative Emission (EVAP) System - Incorrect Flow Detected
Possible Solutions:
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Perform Output Test.
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .
Check Evaporative Emission (EVAP) Canister.
Perform Basic Setting.
Check Pipes between Tank Breathing and Throttle Body.

Error Code: P0446
Fault Location:
Evaporative Emission (EVAP) System, Vent Control - Circuit Malfunction
Possible Cause:
Wiring harness.
Evaporative emission (EVAP) canister purge valve.
Engine control module (ECM).

The recommended spark plug gap for a 2005 Honda Odyssey is .044"

Section 03-13: Evaporative Emissions 1995 Town Car, Crown Victoria, Grand Marquis Workshop Manual DESCRIPTION AND OPERATION Evaporative Emission Canister Fuel vapor emitted through the evaporative emission valve (9B593) is stored in two evaporative emissions canisters (EVAP canister) (9D653) . I think you should have 2 engine vacuum lines, one for each canister.


Evaporative Emission Canister Purge Valve


---------------------------------------------------------------
Evaporative Emission Tube Shut Off Valve The evaporative emission tube shut off valve (9G332) is located in-line between the evaporative emission valve (9B593) and the evaporative emissions canister (EVAP canister) (9D653) . The evaporative emission tube shut off valve control valve is mounted on the fuel tank (9002) by an integral bracket. The evaporative emission tube shut off valve closes the flow path from the evaporative emission valve to the evaporative emissions canister during refueling to prevent overfilling of the fuel tank .

Evaporative Emission Tube Shut Off Valve

The most likely source of your problem is a leaking head gasket. To check it remove all spark-plugs, pressurize the cooling system and inspect each cylinder for signs of coolant.

It is located under the car near the gas tank on a tray with the fuel vapor storage cannister