My dryer will turn on for a few seconds and then stops and all the lights keep flashing

I have no idea

Clothes Dryer Stops and Starts ' HomeTips

www.hometips.com/repair-fix/clothes-dryer-stops-and-starts.html
Apr 23, 2015 - The dryer's heating element works and the motor runs smoothly, But it... and then running the dryer with nothing inside for a few minutes-if it ...

Have you replaced the lamp recently? they can fail if they are on when the storm happens? Please post your model # for more info.

Check the dryer vent to see if it is free and clear.

Sounds like you have it on wrinkle prevent, a feature that keeps your clothes from wrinkling before you pull them out of the dryer. Check your user manual.

may be motor switch or motor x

Its rubbish, it only works when its warm not in the Winter as the heat sensor gets too cold! People are saying that you need to stick a heater by it to warm it up, mental!

The problem is that you stopped a cycle before the program knob reached the "STOP" (12 o'clock on the knob). All you have to do is turn on the machine, turn the knob to STOP, and wait a couple of seconds. You'll hear a tone and the ON/OFF light will stop blinking. Turn the program knob to the cycle you want and- viola! you're good to go!

Most likely the heating element or a thermostat.

aye, see if you can enter the diagnosis mode. What we are looking for is the F-02 code. This will flash when there is a stuck button or user interface problem and only displayed in the test mode. With the unit plugged in and all indicator lights off, select any button except stop. Press for 3 seconds, release for 3 seconds, press for 3 seconds, release for 3 secnds and press for 3 seconds. If you did it right 88 should appear. Press the same button again and if there is a error, it should show up. If no error code shows, open the consol and check the p-5 connector. This will be the interface ribbon to the board. Reseat it and see if the problem stops. Catriver