The computer turn's on then basicaly right away turns off we checkted the computer but we count find anything wrong windows 7 buld 7600 350w auses p5gd1-fm/s please help

it is a facebook scam
he can run win 7 check disc , restorer or run the security system scan that should be installed on the computer

To speak Live Window Customer Support provide 24*7 18002044427 USA.UK.AUS.CANADA Call US :+1-800-204-4427 UK : +44-8000465216 AUS :+61-1800954262 Windows 10 Support Number 1-800-204-4427 USA.UK.AUS.CANADA

Buy and install the 'Viewscan" scanner driver utility.
Then: Found that for windows to reliably see the scanner start windows, go to device manager, turn the scanner on and as it goes through its setup, right mouse click and select "scan for new devices" Windows 7 will now see the scanner right away.

Hi Dwayne,

You can view the scanner counter as follows:

For Windows XP:

1. Turn the scanner on connected to your PC. Open My Computer, right click on the displayed scanner model
2. Click Properties, under the "Device set", you can see the total page count.

For Windows 7:

1. Turn the scanner on connected to your PC. From the "Start" menu, click on "Devices and Printers"
2. The scanner model is appered in the window.Right click on the displayed scanner model
3. Click 'Scan Properties', under the "Device set" tab, you can see the total page count.

Thanks & regards,

ScanCare

Hi Dwayne,

You can view the scanner counter as follows:

For Windows XP:

1. Turn the scanner on connected to your PC. Open My Computer, right click on the displayed scanner model
2. Click Properties, under the "Device set", you can see the total page count.

For Windows 7:

1. Turn the scanner on connected to your PC. From the "Start" menu, click on "Devices and Printers"
2. The scanner model is appered in the window.Right click on the displayed scanner model
3. Click 'Scan Properties', under the "Device set" tab, you can see the total page count.

Thanks & regards,

ScanCare

I would update the drivers, check with the chip set manufacturer for updated firmware and run diagnostics on the RAM and hard drive.
That should cover most angles.

To put it simply the power source is too weak. Get on that is at least 450W for a no name or 400W certified one.

we changed out the light buld... now it works fine.. funny thing was projector was brand new just out of box... you could see first thing there was a brown spot in the center of the buld creating the spot apparently after it heated up.... thanks again

This is a CRT based set and when the protection circuits kick in and shutdown the set, the standby light should be blinking in a repeated count pattern. Please post that count here. That will indicate the circuit that caused the shutdown. There are common failures that can be listed for each code.

Thanks,
Dan

change the lamp