Errore 106 - Google Chrome

Some Roblox players report that every time they try to join a friend, they get the error code 106. The error is reported on Xbox One and usually occurs for people who first try to join an online session. Read blog for solution

Error code 106 is Engine Control Error. Try replacing the engine control pcb.

From what I have been able to figure out, error 106 is coming from your firewall. Reduce the protection of your firewall and see if that solves the error from happening.

81. - 95. (0101xxxx) Phase 2 to 3 - Display/ Motor Controller.
See fault code 106
104. (01101000) Phase 2 to 6 See fault code 106
106. (01101010) Phase 2 to 3 - Display to Motor Controller module
Communications Errors (Phase 6 IW also)
These faults are reported when the Display module detects an error in the
communications between the Display module and the Motor Controller module.
Primary Source: Display module.
Action:
Replace Display module.
Secondary Source: Motor Controller module.
Action:
Replace Motor Controller module. If the new Motor Controller module corrects the fault, refit the original Display module.

This question greatly depends on what generated the error. What caused this error?
As a starting point, if it was software, check this website out: http://kb.iu.edu/data/agng.html
If it's something else, let us know and I'd be glad to help.

Error 106 occurs when there is a problem with Microsoft Windows. The Error are often critical system errors caused by corrupt and missing registry data. This error must be fixed immediately to prevent further damage to the Windows, such as system not responding, blue screens, can't open programs...
Use Reginout cleaner in order to fix registry errors

YYYY
106: FATAL ERROR
An error has
occurred which
requires service.
YYYY = the general
cause. 106 = error
number.
Try turning off the
printer then turning it
back on. If this does
not remedy the
problem, write down
the message including
the error number
“106,” then call your
authorized Oki Data
Service Dealer for
service.
Note: If you see a
series of octets
containing letters and
numbers scrolling
across the display, be
sure to write these
down also and report
them to the Service

Fuser error. Replace fuser or if no-go, Main board.

OKI C 5800Service Call 106:Fatal Error.

Fuser error. Replace fuser or if no-go, Main board.

restore your system to previous date where its working fine then check

I suggest go to Start/Settings/Control Panel/Add remove programs.
Check and see if the program is in list and remove it. While in control panel go to system/Device Drivers check non have a yellow mark on them if so reinstall drivers or upgrade Reboot and try again.