The belt is making a scraping noise when you walk on it. i see nothing touching the belt proform crosswalk 375e

Hi Paula, I know nothing about it, you could lift the belt and use DW40 or vegi spray where it's squeaking. Nothing beats a walk in the park. Greg.

can you determine where the noise is coming from . under the front hood or back. if you can remove the hood and look at the drive belt for fraying . also look at walking belt for fraying. any loose piece will hit something and make noise with every revolution

Walking belt or drive belt loose. If you get noise while this is happening your front roller is likely bad.

If it sounds like metal rotating on metal then it could be a a(roller bearings or b( motor bearings. LUBE INMEDIATELY. + DECK BELT LUBE VERY URGENTE, MAYBE YOU HAVE A WORN DECK TIME TO CHANGE THE BELT.

God bless you

1) lube the deck belt very well
2) lube the rollers bearing too
3) lube the bearing from the main motor,+test the pulley+belt for replacement need lubrication go to the repair shop.
4) otherwise you must call some tech for repair.
see the video.
God bless you

You need to adjust the roller tension, The adjustments are at the sides of the treadmill by the rear roller. Sometimes there is a cover over them.

If the noise is coming from the walking belt this could be due to sand or grit getting under it. These belts are big electro-magnetic generators. The attract sand and grit to them. Usually it will make a high pitched sound when there is sand under the belt, especially if there is a mylar or plastic sheet under it. If this is the case the sheet can easily be replaced.

This definitely sounds like the drive motor. One way to check is to remove the drive belt and run the motor without the walk belt connected. Obviously if you still have the noise it will be a motor issue. If not then it will be one of the 2 rollers. Good Luck! Tim

it is the edge of the belt on the deck. Walk in the middle. Eric