I was experimenting with my remote and clicked a button. The picture immediately started rolling vertically. I cannot get it to stop. Help?

adjust the vertical hold button
get the set repaired

this fault is caused by defective electrolytic capacitors in the vertical deflection circuits, they need to be changed out, do this before it causes more problems, there are no adjustments for this anymore.

with your control push the set up button and on TV Output choose NTSC and Video Output choose S- Video.

problem is bad hyper module or can have tech repair it with capacitors

Somehow the TV setting on the DVD player was set to PALS so we changed it to the proper setting.

unfortunatly no. the vert hold is set by black bars at the top/bottom of the video signal (outside of the viewable area). it sounds like your VCR or tape is damaged.

do you have cable to the set or are you on rabbit ears if on ears adjust antenna for the strongest signal.

It ended up being the Verizon Fios box. We recycled it and the picture stopped rolling. Thank you for being here to help. If I have any future questions, I'll definitely use your site.

Press the n/p button on the original remote control that came with the unit. It's located between the stop and rewind buttons.

This is a problem with the low voltage condition in the main power supply or the sweep supply, or there is bad capacitors in the vertical driver circuit, or the PIP circuit if there is one. the best way to troubleshoot this would be with a schematic, measure all the voltages and see if there are any lower then normal levels. In the vertical and PIP circuits, you will need an ESR type capacitor meter. if you dont own this equipment, or have had no experience working on solid state electronics, play it safe and call in a tech to assist you in this repair. Good Luck Please dont forget to rate this thread.