I have the HP F4480 All-In-One Printer how do I align it so it will not print blurry copies?

If you haven't already, you may want to do a print head alignment. especially if you have changed the ink cartridge(s).

http://h10032.www1.hp.com/ctg/Manual/c01714002.pdf here is the manual

The HP F4480 likely has a malfunctioning ink cartridge which is causing the printer hang (i.e. internal micro-electronics damage inside the HP 60 color or black ink cartridge). You can verify the electrical condition of both HP 60 ink cartridges by activating the Tap 41 diagnostic test report (see video here for complete instructions):

http://inkjet411.com/?page_id=440 (HP 60 - Deskjet F2400/F4400/F4500 models)

1.While holding the Power button, press Cancel (X) button 4 times, then press the Color Copy button once.
2.Release the Power button.
3.The 'Tap 41' diagnostic test print should print.

Providing the color cartridge is partially functioning the Tap 41 diagnostic test print will be printed (this is a forced service print test which is mainly used for the evaluation of ink cartridge electrical health). A good HP 60/60XL color cartridge should display 1248 good nozzles, while a good HP 60/60XL black ink cartridge should show 336 good nozzles. If the results yield anything different then the ink cartridge is likely damaged and will need to be replaced. Refer to 2nd video on how to read the printout.
http://inkjet411.com/?page_id=440 (HP 60 - Deskjet F2400/F4400/F4500 models)
http://inkjet411.com/?page_id=444 (HP 60 - Deskjet F4200 model)

If the printer attempts to print the diagnostic test pattern (1 page) then the printer is generally considered operational and functional, if nothing is printed, but the printer attempts to print the pattern, then the tri-color ink cartridge is either empty, clogged or severely electrically damaged (black ink cartridge is not used). You can remove the tri-color cartridge, reactivate the tap 41 test and the printer will print the diagnostic test print in black ink.

For additional support please visit http://www.inkjet411.com

-Thank you

Before printing preview what will be printed. You can also decrease the width of the columns, or change orientation from portrait to landscape.

I have a Canon printer. Whenever pictures or text gets a double or blurry image I open the printer solutions menu. It sounds as though there is a problem with inkjet alignment. By clicking the realignment button the printer will automatically realign the jets. I usually test the alignment by printing a page from that program. All the line segments should line up.

Align completed?.. Take cotton wet cloth( dip cloth in to normal cold water sqeeze it) clean encoder strip left to right once gently..check any markings on it?..do align once again I hope your problem will shortout..

You may need to do an alignment of the print cartridges. 1. Open the HP Solution Center 2. Click on Settings 3. In the Print Settings section, click Printer Toolbox 4.Click Align the Print Cartridges 5. Click Print Page An alignment page will be printed. Placed the alignment sheet with the printed side down on the right front corner of the scanner glass. Press the scan button to complete the alignment.

You may have to do another alignment of the printer.
Do a Clean the Print Cartridge cycle first.
This will allow the printer to print a good alignment page.

the problem is with the main board. I fixed two of the exact same problem before.

Hey,
Your problem could be because of bad alignment. That means paper alignment and printer alignment don't match. There will be instructions in,your manual to properply align your printer. 
Hope this helps. 
Thanks