An index of 1202 effects on mixer lost list - Behringer Rx 1202fx 12 Channel Line and Microphone Mixer

Try watching this
https://youtu.be/Yz3sdbjhwUY

Looks like both units accept 1/4" jack & I think the 1202 is unbalance out, so just use a standard screened mono (i.e. 2 pole "TS") jack to jack lead & you should be fine. Good Luck! :-)

It sounds as if the input is too low. what happens if you plug whatever is going into the stereo channels into a pair of mono channels. Or are you taking about the phono stereo tape input?
The stereo channels are line level whereas the other channels have both line and mic level inputs, what are you trying to put through the stereo channels? You must make sure the gain switch is set to the -10dB to get the most sensitivity (the mono channels have about -132dB max sensitivity BTW) You probably need a different mixer or possibly a submixer if you are needing more than 4 low level inputs.

You'll need to connect both your PC and the Mic to the mixer, you'll need phantom power switched on at the mixer for the mic to work, you then take the two track out to the Aux input on the receiver.

http://www.bandl.hu/pdf/audio/mixer/phonic_mm1202a.pdf

Here's the answer

Please view videos on YouTube. Search for "mixer setup". There are a bunch, and the information and techniqes are the same for almost any of the analog mixers. You might refine the search to Mackie mixers.

Your best bet is to contact Mackie directly for a distributor in the UK.

The contact information is listed below.

Dan

LOUD Technologies Europe PLC GENERAL CONTACT Unit 1 Century Point, Halifax Road. Cressex Business Park
High Wycombe, BUCKS, HP12 3SL, UK
Phone: + 44 (0) 1494 557 398
SALES Email: [email protected]
SERVICE Email: [email protected]

111111111111111111111111111111111

Here you go:

how u hook up a mixer