I have problem, with my door garage. it desn't

check down force adjustment. will it go down if you hold down the wall control button?

You have to adjust the safety pressure sensor. It is set to too light a pressure. Check your manual for the adjustment.

The model number you give is a part number for the logic board. Does your remotes work? Is it only the wall control that isn't working?

It definitely sounds like a sensor problem. In normal operation, one sensor will have an amber or yellow light on, indicating power to the sensing circuit. The opposite sensor should have a green light on. If the yellow light is not on there is no power to the circuit due to a broken wire or circuit board failure. If the green light is not on or is flickering, the sensors are not aimed at each other or the light path is blocked.

There are probably two photo sensor near the ground at either side of your garage door. They are there to stop the garage door from closing if there is something in the path of the door. Likely one of the sensors got bumped or moved and it is not lining up correctly. Adjust the sensors until they line up and allow you to close the door by pressing the button on your remote once.

It could be the garage door motor that is acting up. Try closing it with the button in the garage. If that's not the case, you may need a different garage door opener.

If the main light is flashing 10 times when the door reverses when closing it is a door sensor problem. You can override this with the door control but not with a remote. Make sure the door sensors are pointed at one another and the small light on each one is on and not flickering.

What usually happens is a sensor gets bumped so that they no longer are pointed at one another. They must be for the light on the second sensor to come on. Tweak them and see if you can get the light to come on. If you can't you either have bad wiring going to that sensor or the sensor itself has quit working.

Hello,

There should be 2 sensors on the bottom of your door on the inside, 1 on the right side and 1 on the left side.
These sensors serve 1 purpose to send a beam or reflection to each other.
If something is blocking this reflection or is in front of the sensor the door will always come back up.
It is a safety feature so nothing or no one gets hurt when the door is closing!

readjust the sensor controls on the side of the unit