How to test motor in crosley washer - Crosley Washing Machines

Crosley Compact Top Load Washer Error Codes Sears PartsDirect

This would be a control board issue, pull the panel apart and check for burned connector and circuit board overheating. If the control boards are showing signs of heat damage you may have a defective drive motor as well.

1) When it starts humming measure the voltage at the cord to see if it is dropping. f you have fuses they can become corroded so rotate a few times till the problem goes away.
2) If the problem persists remove the motor for testing. Any repair shop can test the motor. You can test it if you can read the diagram.
use a cord and hook to terminals behind inspection plate. Step on motor to keep it in place and plug in. Test both speeds. If the problem persists replace the motor.
Good luck

check belt is not Brocken filter is cleaned also can be the motor not turning check brushes or that the motor is not burned

SOUND LIKE IT REPLACE MOTOR AND THAT SHOULD TAKE CARE OF THE PROBLEM

Sounds like you have a motor issue, listen when you press the start button, if you hear any squealing noises or any of the noises the system usually makes doesn't occur, then you probably have a motor issue, you may need to have your motor replaced

JERRY,
IT SOUNDS LIKE YOU GOT TAKEN ON THIS WASHER. A NEW WASHER NORMALY WORKS, BUT IN SOME INSTANCES, LIKE YOUR CASE, IT COULD BE THE BELT OR THE MOTOR COUPLING. WHAT I WOULD DO IS CALL THE PLACE WHERE YOU GOT YOUR WASHER FROM AND HAVE THEM TO BRING YOU A NEW REPLACEMENT. THERE HAVE BEEN COMPLAINTS ABOUT WASHING MACHINES NOT WORKING RIGHT WHEN THEY WERE NEW. I HOPE THIS HELPS YOU AND ANYBODY ELSE WHO READS THIS WEBSIT, BECAUSE THERE IS NO SENSE IN THE STORE SELLING A BRAND NEW WASHER WHEN IT ALREADY LEAKS.
RODNEY

Dear customer,


 We recommend u to do the following when the washer doesnt spin or agitate,

1. Test the lid switch
   
2. Inspect the motor coupler
   
3. Inspect the drive belt (belt drive only)
   
4. Inspect under the washer for soot (clutch)
   
5. Test the motor
   
6. Inspect the pulley
   
7. Test the transmission
   
8. Inspect the agitator
   
9. Inspect the pump coupling
   
10. Test the timer control
    
11. Test the centrifugal switch
    
12. Test the water level switch
    

for more details about self testing plz try the link  http://www.acmehowto.com/howto/appliance/washer/washer.php


Plz rate this solution.. thank you.. 

check your breaker i think you losted a leg...this is a 220 dryer,,make sure you have true 220..keep me posted on the job...

the drain pump is blocked and will need to be cleaned out as the humming is comming from that pump motor by the sounds of it
so check that
cheers