LOST THE VOLUME ON VIDEO, HOW TO FIX? - PowerShot Canon Cameras

Yeah, you likely blew the sub. Could be the amp in the sub or the speaker driver.

I never recommend running video through any receiver. It's best to connect your playback or broadcast devices directly to your monitor.

Please be sure to double check that the volume for BLUETOOTH on the device (phone, tablet, etc.) is also turned up. Please note that the volume buttons on the speaker may not always control the bluetooth volume via the device.

If you continue to have trouble feel free to contact the manufacturer at [email protected] or going to http://www.contelusa.net

Youtube has its own "mute/volume-control" level.
Unmute the video, and increase the volume-level.

The VM9312 has a volume knob on the unit's faceplate. Just rotate the knob on the left (a little below the optical disc D slot) clockwise to increase the volume. Turn it the opposite way to lower the volume. (If you have the knob set to the maximum volume and then lowered the volume with the remote, you may need to reset the unit; see below.) If you push in and release on this button, you press Enter or confirm a setting when you are in any audio settings menu.

If the volume control isn't working, check if the mute is on. Press once to toggle the Mute. The mute button is just below and near the right side of the optical drive slot.

If you still can't change the volume, check if you have the wiring correct and no shorted wires. Look for damage at the speakers (or evidence of mice chewing on the wires). Also check your audio balance. See the manual page 12 here: http://www.voxxintlcorp.com/docs/common/VM9312/VM9312_OM.pdf . You may also want to try a system reset. (Press and hold the reset button for a few seconds by using the tip of a ballpoint pen in the little opening at the lower right hand side of the faceplate.)

I hope this helps.

Cindy Wells

If using cable you may be able to route signal to rear audio and video inputs--doubt a vcr will help.

disconnect power from set and or a box if used--wait several minutes and power up again--HDMI can cause issues and does not like connections being made if units are on.

ebay #390076698974 $8.95 buy it now

if TV outputs are okay.Then simply connect TV into another input on reciver, AUX,TAPE,VIDEO ETC...if problem persist then output from tv is the problem..check settings on tv

i have the same problem. i have a rx-v661. i goto the zone 2 settings and try to change the volume and it says VOL FIX. I cannot hear anything out of zone 2. It takes the current volume that is in zone 2, but i cannot hear anything. it has been working fine for at least a year.