Water spots of forks & knives and dishes not

If the heating element is fine then the problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into your dishwasher and removes the hard minerals that leave those spots. It is very affordable and even has a money back guarantee. You will love the way your dishes look with this product.

I always put the handles down in hope of the spray hitting the business end better.

I'm sure there are arguments for handle up too, but I put the handles down.

lp

Are the holes in the spray arms clogged? That will cause it and they're not too hard to clean out.

The problem is hard water. Go to www.dishwasherfilter.com. They have a new product out that solves this problem once and for all. It filters the water entering your dishwasher and removes the hard minerals that cause these spots. Very affordable and guaranteed to leave your dishes looking amazing every time.

Hi

First of all please check the Water temperature by using a thermometer inside the dishwasher to measure the water temp. It should be as close to 125 degree F to 140 degree F as possible. Now try using the temperature boost feature if your dishwasher is equipped with this cycle feature and check if this will help your wash ability issues.

Now check the Powder soap by making sure that you store your soap in a dry environment and it is not stale and clumping together. Possibly try a different detergent like a liquid or gel. Also, make sure the dishes are loaded properly, or dishwasher is not overloaded.

To check the proper filling dishwasher will fill with water up to and around the heating element. If water is more below the heating element, you may have low water pressure or a problem with the fill valve. Try & listen if it sounds like it is spraying the water around with enough pressure.
For low water pressure, try to clean the screen at the entrance of the fill valve, sometimes the fill valve can fail and not allow the proper water into the dishwasher and may need to be replaced. And, check the spray arm and pump cover for splits or leaks

Low water fills are a very common trouble maker with today's dishwasher.

Please do rate this solution and revert for further assistance.

Thanks
Rylee

they must have changed the way they treat the water in your area. those spots are caused by hard water. www.dishwasherfilter.com has a product out for this problem. it filters the water going into your dishwasher leaving them spot free and crystal clear with every load. you will love the way your dishes look.

I think your dish washer is starting to go out. We have a Kenmore dish washer (unsure if the model is the same), it started with not cleaning the dishes well to not sanitizing and now it doesnt dry. We are actually replacing ours today. We we noticed that it wasnt cleaning properly (water spots, or not rinsing well) we too added Jet Dry thinking that that would solve it. We soon discovered that it didnt help at all. Hope this helps you.

Don't know much about Dishwashers but have you tried a descaler.
Is the water spraying out as normal.
Is the water actually getting hot, could be a heater element problem.

If you look here you may get some other ideas just by looking at the parts and diagrams. Copy the whole link and paste in to your browsers address bar.
http://www.partselect.com/AdvancedModelSearch.aspx?ModelNum=MDB6000AWW&mfgModelNum=&fkMfgID=1
Other than that it looks like and engineer may be calling.

where to find the sand filter on a maytag dishwasher?