I would like to find out the qualifying times and results for the British super sport 600 race held at brands hatch on the 20 th June 2004

what country
what county
what city
horse race
dog race
foot race
what time
Do you think that you left out a lot of important details in this question

no idea to be honest earlier jeeps had then at the front of the wing down below as i remember ?? newer one would i imagine be in the electrical box under the bonnet near the battery

Bearings come right out from outer side,inside is still held by the seal.Push the bearing and seal out fron the outer side with a long punch.Replace with a new seal.Drive out bearlng races with a hammer and punch to replace them also.

AMSOIL Series 600 DOT 4 Brake Fluid is a good brand of brake fluid. Series 600 DOT 4 Racing Brake Fluid (BF4) AMSOIL Brake Fluids provide superior high-temperature performance in auto/light truck, high-performance, racing and powersports applications.-------------------------------------------------------------------------------------
Super VAG K+CAN V4.8

release the soft top at front and rear, hard top first if it has one,fold rear of soft top up and tie around rear door frame with cord or a piece of wire remove rear parcel shelf trim and sound insulation you will then see a metal access panel held with 10mm headed bolts 3 are a bit difficult to remove remove them all and remove panel much more room to work now belt adjuster is got to from underneath

The better solution is to fix the hatch so it closes tightly. The latch hooks on to an adjustable loop. The hatch closes on to the rubber seal: if this is damaged, fix or replace. There may be some adjustable rubber bump stops as well. Lastly, check that the door ajar sensor is not loose.

Hello,

To replace the left rear turn signal light, please follow the steps below:

1. Open the rear hatch of your van.
   
2. There are two black button like protrusions behind the hatch next to the turn signal lamp.
   
3. Pry these out and remove lens.
   
4. Replace bulb.
5. Then reverse the process th reassemble the hatch back together.

Hope this helped. Thank You for using FixYa!!!

You have to take off the back hatch pull down strap. It is held in place with a large screw likely concealed under a decorative cap. Then the whole rear cover on the inside of the hatch can be removed. I have a PDF on this somewhere I could dig up. Contact me if you want it emailed to you. As they say a picture is worth a thousand words and there is drawings in the PDF.