Everyoung treadmill Is there a front drive roller from another company that will fit an Everyoung 88800F treadmill. I am having trouble finding this part.

https://www.manualslib.com/manual/150350/Sears-Everyoung-88800f.html

see the video attached. and lube the rollers bearing front+back.
God bless you

go for free download: www.fitness.manualsonline.com or www.manualsfactory.com or www.retrevo.com

sincerely. God bless you

This might be of a little help. My treadmill is not an everyoung but on the control panel it has two buttons which are used for adjusting the position. While i was searching for a solution on this i came across an individual whop has one for sale you could call him and find out if you are in the US here is a link to his advert.
http://fayar.craigslist.org/spo/2036394410.html
Hope this solution has been helpful?

I have a problemwhen i start the ever young model 75900F
on screen F1
please send me solution

e2 normally refers to error in the speed sensor - iff the treadmill starts moving and then stops it is speed sensor related, otherwise if it never starts at all you will need to test your drive motor with an external 18v battery (cordless drill battery) to see if the motor will still turn. if it still turns then that narrows the problem to the motor controller which also means that the motor relays are not working and the controller would need replaced

If the problem is in the drive belt, either the drive belt will stop when stalled or the front roller will stop when stalled. Follow this procedure: First remove the key and UNPLUG THE POWER CORD. remove motor shroud, then find the motor mounts. Many motors in Icon treadmills have a main pivot joint in which a bolt runs the full length of the motor mount. This bolt will require loosening to provide maximum adjustability.
If your treadmill is not equipped with a bolt as described above, the drive belt must be tensioned by hand. While one person applied increased tension to the drive belt, the other person should tighten the motor set bolt Tighten the bolt and test. If the problem is not corrected, repeat steps above and retest.
If the motor, drive belt, and front roller continue to turn when the walking belt is stalled, the problem is with the walking belt slipping on the front roller. Follow this procedure:
First remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller adjustment bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened. Rear Roller Adjustment Bolts


If the drive belt continues to turn but the front roller stalls, you may have a broken front roller pulley and front roller must be replaced.
Follow this procedure: First remove the key and UNPLUG THE POWER CORD. remove motor shroud. Loosen the rear roller and remove the two adjustment bolts. Some models have a spring loaded tensioner on the right hand side so be careful when removing these bolts. After the bolts have been removed, remove the rear roller end cap(s). The rear roller should now simply slide out of the walking belt.
Remove the motor hood. Using a black permanent marker, make a mark on the front roller adjustment bolt on the motor compartment side at exactly where it fits flush with the roller so you will know where to retighten it later. The adjustment bolt is on the right hand side of the front roller. Then remove the bolt with a 7/16” wrench. then remove front roller and replace with new reverse procedure mentioned above

End up dismantling the unit and disposing everything except for the motor and belt and rollers. Was a good machine except for no parts support.

Since the drive pulley is slipping on the roller itself, then the front roller will need to be replaced.