Re: No break lights. i have tail lights but the break...
Check the brake light switch behind brake pedal. it could need adjustment or its bad.so when you put foot on brake it makes no contact to turn on brake lights. good-day !
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If 3rd light working then brake switch is not the problem, so it is looking like a wiring problem near to the rear light cluster. Run a live feed to the brake lights to rule out a faulty bulb holder. Probably not a ground problem as tail lights work, but wouldn't hurt to check that out.
eBayFind great deals on eBay for Dodge Charger 3rd Brake Light in Tail Lights. ... Will fit:2011 - 2013 dodge charger. ... I swapped this out for the third brake light W/ backup camera so I no longer need this one. Item is .... There are three wires; positive driving / strobe flashing blinker mode, positive backup / brake light mode and ...Missing: deck
Mar 15, 2009 - 12 posts - 3 authors
i would try and test if you even have power at the 3rd brake light. that way ... work, the circuit is working up to S348 splice where it splits to left/right/CHMSL. ... You'll have to undo the rubber boot to examine the wire. ... 2011 Dodge Charger R/T Plus AWD- Redline - 5.7L Hemi Registry #1650 Tbird100636
First replace the tail light bulbs. The tail light and brake lights are different filaments in the same bulb. it is very possible for the tail lights to go out while brake lights still work. And somtimes the tail lights can blow out together.
If you change the bulbs and still dont work then look for other problems.
The problem is in the stoplight switch. It is located under the dash. When you push the brakes, the switch contact points close. When you let off the brake, the open, turning the brake lights back off. Also your cruise will not work if it is getting a signal that the brake pedal is being pushed.
So you already have the screws out. You simply have to pull it out. It probably have a small plug or *** on the back side to help hold it in place. YOu can pull the unit fairly hard on it with out breaking it, just be firm with it and it should come right out. I'm not sure about the 3rd light, how it is mounted as well. Are you just changing the light bulb in it or changing the cover? If your just changing the bulb or cover you should just be able to take the screws out of the cover and use a small screwdriver to gnetly pry it off.
Do you mean "Brake" lights?
×