Top 20
Thermador 30", 36", 42", 48", 54" Wall Hoods, PH Questions & Answers
My customer has a Thermador
The speed module is very simple: a triac with some extra components to modulate it, it's build exactly the same as the one from a vacuum. That speed module is controlled from the touch screen - are you sure the touch screen is operational? That's relatively easy to test - just put a potentiometer where the control signal goes and see if moving the potentiometer changes the speed.
Replacing the TRD sensor in a Thermador double oven.
Hi,
Please look on page 40 of the manual for the Thermador SMW272 B Service Manual to find specific directions for removing the sensor. You can text "SUPPORT" to 53730 for quick access to such documents or call 1 (800) 735-4328 to speak to Thermador.
Thank you.
10/17/2022 6:20:31 PM •
Thermador...
•
115 views • 0 helpful votes
Thermador model GGCV30 gas cooktop
The flame spreader in the middle of the hob has a small hole that directs as jet of gas to the igniter. Put it in a pan of water and dish soap and gently heat it to almost a simmer. Be careful, it will want to boil over. Leave it to cool and and rinse it well paying attention to the holes in the edge. Blow it dry and try again.
10/26/2021 11:01:25 PM •
Thermador...
•
92 views • 0 helpful votes
I have a Thermador PRSE304SLP
4 burner stove. The front burner on the left will not ignite. It does have spark. All the little holes are clear in the cap/cover.Everything is dry. It’s been like this for quite a while. It does not click like the other three when i push in and turn it and does not get gas. Is this a bad gas solenoid ?
you hear clicking and see sparks as you turn the burner knob, and can smell that gas is flowing okay, but the fire won’t ignite, it’s possible that the gas feed is cloggedThis is a super quick and easy fix – simply lift off the grate (make sure it’s cool to the touch), take off the burner cap, and lift the burner out from the range top. For some models, you may need to unscrew the two screws holding the burner in place – for this, a regular nut driver or socket wrench will do the trick.Have a look at the small, nearly pin-sized hole in the back of the burner. This feeds the gas through to the igniter to get the fire lit, and can frequently get blocked up with grease or any other kind of debris. Just give the burner a thorough clean, sticking a toothpick, needle, or other similarly sized tool through the hole to clear it up, and pop it back on to your stovetop. The gas should feed through and the burner should light as usual.
11/25/2020 3:10:35 AM •
Thermador...
•
168 views • 0 helpful votes
Why doesn't it heat?
Your mystery Thermador appliance is broken. Contact your local service department.Broken elementBroken thermostatBroken Switchor heaven forbid ... A failed mainboard!https://www.fixya.com/cars/r25931461-get_good_answers..
11/8/2020 4:39:51 PM •
Thermador...
•
100 views • 1 helpful votes
Thermador bottom freezer 2008 year error code E11
That error is indicative of a failure of the software in the display module. You can try to reset it by unplugging the appliance for a few hours. If no change, the display module will probably need to be replaced.
10/11/2018 4:56:45 PM •
Thermador...
•
807 views • 0 helpful votes
Not finding what you are looking for?