20 Most Recent
Galaxy Radios DX- 88HL Base CB Radio - Page 2 Questions & Answers
Got pop noise
Popping sounds are from the the ignition - spark plugs, wires and distributor. Most modern cars have "radio resistor plugs" & "spark plug wires" installed from the factory. If unsure on an older car, check under the hood and inspect the wires & plugs.Make sure your radio AND antenna system are solidy grounded. Poor grounds can allow all kinds of strange sounds and erratic behavior from the radio. Also, connect the + & - power leads DIRECTLY to the battery. You can pass the + lead through a dedicated relay that opens when the key is removed if you want, but avoid like the plague connecting the + lead to a terminal in the fuse box and the - lead to an arbitrary grounded point on the body. Direct connections to the battery helps to prevent a way for noise to enter the radio on the power leads.You may also be hearing the electric fuel pump located in the fuel tank on many newer cars. Solving that sound is very difficult.Good luck!
What are the buts &
Assuming you're talking about the Galaxy DX88HL, and assuming the mad has been done to reach the 11 meter band, you press the band button in, that put's you to the E-H banks, select the E/A bank which is high bank E. with the frequency counter on, it should read 26.965 for channel 1. If it reads 26.975, then your +10KHz switch is on, turn it off. you'll then be properly set for 26.965 (ch.1) - 27.405 (ch.40). You also have 5 "hidden" frequencies, these are at ch. 3, 7, 11, 15 and 19. To get to the "hidden" frequencies, go to any of the channels listed and turn on your 10KHz switch. Those frequencies are not attainable on radios that do not have a +
10KHz switch or a clarifier capable of sliding that far over. To do repairs and for a full list of schematics, diagrams and so forth, I suggest this site, it has the most coverage of the Galaxy DX88HL as well as other galaxies that I've been able to find. http://www.cbtricks.com/radios/galaxy/dx88hl/index.htm .
I need A operators manual
- If you have any comments please feel free to leave them here.
- Hope this helps and thank you for using FixYa.
Regards,
Tony
Do you sell protection diodes
- If you have any comments please feel free to leave them here.
- Hope this helps and thank you for using FixYa.
Regards,
Tony
Not finding what you are looking for?