20 Most Recent
Hoover SteamVac F5914-900 SpinScrub Upright Vacuum - Page 4 Questions & Answers
Hoover changing belt
There is no belt in Hoover Steam Vac. A gear box turns the brushes. The nylon gears wear down, eventually, but can be replaced. Check this out: http://www.youtube.com/watch?v=n-vPOk9kEag
Handle came off of the container that the dirty water goes into
If it 'came' off it's just a matter of re-attaching it. You weren't very clear in your post. If it 'broke' off, then it's best to order a new top from your dealer. If the unit was something you just picked up at a yard sale. See if you can find another.
Hoover steam vac spin scrub won't suction the water
I fixed my problem by repositioning the tunnel that is on the front of the pick-up tank. It had moved out of position and not allowing a tight seal. It is the white plastic piece that slides a little bit. Good luck.
How do I replace the handle leaver on my Hoover steamvac F5915 900?
Go to go hoover .com type in your model,ask for blueprint/schematics,look at blueprint ,find your part,cause they will have it, find the part number/price,and they will ship you the part,it's cheaper to fix it yourself, check it out, if I can do it, so can you, if not then pay to have it fixed, I am a cheapo,I fix it myself,also YouTube will show you how to fix it
Can't hook up power cord to main motor on Hoover model F5915100
You have a black and white and green wire. Green is ground white is neutral, black is hot . Should say on the motor either L1 = black wire. L2 = white wire , G = Green wire or it say H = black wire, N = white wire , G or the symbol for ground = green wire
F7452900 brushes not turning
The usual reason for this is that the air driven turbine which turns the brush has seized up. Remove the brush assembly and insert a screwdriver into the square hole that the pin on the brush normally fits into. ( Make sure the pin has not broken off). If you can't turn it, the turbine has frozen up and must be replaced. If you can turn it, the problem lies elsewhere. Pull out the lint screen on the bottom of the machine and be sure it is clean. Be sure the brush control is set properly, and be sure the dirty water tank is firmly in place. The turbine will not turn without the lower tank in place.
Not finding what you are looking for?