water pump cover, under that you will see the impeller and it should have a 6mm bolt, (10mm head), that you will need to remove. Remove the bolt and then the impeller will lift off a "D" shaped shaft.
...water pump seal before it leaves past the radiator cap to the over flow. It is the steady/constant drip that needs to be addressed. I assume you replaced the impeller shaft as well as the seal. It is ...
...water pump seal and tranny seal. Is this correct and if so how do I do this and should I also replace the impeller with the newer 06 model with hole in it and the shaft. I just got this bike so any ...
Question about Honda CRF 450 R Motorcycles
Water pump is leaking on my 2001 Yamaha YZF 426 motorcycle. I cannot figure out how to get my water pump off my bike. I have taken the protective plate off, but cannot get the water pump to pop off. I
Question about Honda CRF 450 R Motorcycles
...water pump housing? A leak on the O-ring seals on or sealing the spinning shaft. It is a known issue because a Water Pump Service Kit is readily available. Motorcycle Water Pumps for Yamaha YZ250 for ...
water pump housing i already changed all the seals and the impeller shaft and it is still leaking. plz help CHECK THE BEARING BEHIND THE IMPELLER I had to replace the shaft as well in mine so it would
Question about Honda CRF 450 R Motorcycles
...water pump? How do I remove the bearing on the inside of the water pump on a YZ426F? You need to remove the water pump housing, the impeller from the outside then remove the engine side cover. You ...
...water pump leaking from weep hole what seals need to be replaced and how do you get the impeller off you get the impeller of from removing the complete side case ( not only the water pump cover) then ...
...water pump. All pump seals and impeller have been replaced but problem of leaking still there. System topped up & header tank is full. Initially suspected impeller shaft as it was rusty. u have ...
...Water pump seal change My 00 yz125 was dripping coolant from the weep hole so i went out and bought the pump gasket and seal but i am stuck at the impeller wheel - do i need to take the entire casing ...
162 questions posted
Usually answered in minutes!
63 Questions
50 Questions
47 Questions
4 Questions
6 Questions