plug. Remove right side power valve cover, and clip and spacer for the power valve arm. Remove four cylinder nuts. (If you remove the lower radiator hose that goes between the left and right radiator,
Question about Honda CR 125 R Motorcycles
...depends on where the crack is located. The engine is actually separated by the engine block and the cylinder head. CYLINDER HEAD - located on the top of the engine where the spark plug is located ...
I have a cr 125r and i have boared out the cylinder and put a bigger piston in it. i installed the pistion and new ring in the cylnder and it fit tight but was a good fit. i pushed the kick start a ...
...the engine there was hardly any compression. I used a electronic bore scope and the piston and cylinder wall look ok. There is nothing in the exhaust and the exhaust port is clear and ok sounds ...
2003 CR125 how to remove cylinder head bolts I got a new cylinder and need the bolts off the old one? vice grips , stud extractor , put 2 nuts on and tighten together and pressure the bottom nut off ...
how much torque on cylinder head nuts need to know how much torque to put on cylinder head nuts 20 - 21 ft/lbs
need to know the torque specs for cylinder head torque on cylinder head nuts torqued to 20 ft-lbs. Torque in steps using a criss-cross pattern untill you get to 20 . good luck.....
Honda CR125 I have a 2002 Honda CR125R and the piston has a lot of movement in the cylinder block and I can't find a spec. for piston to cylinder wall. Go to this websit and select discuss this bike: ...
Question about Honda CR 125 R Motorcycles
what other year cylinder head will fit a honda cr 2003 125 I searched for this and found that no other machine has this cylinder head, and that it appears as though there were 2 versions of the same ...
80 questions posted
Usually answered in minutes!
188 Questions
35 Questions
38 Questions
2 Questions
1 Questions