...Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start properly then shut off the gas and ...
turn each screw one and one half turns outward. Set the idle speed with the idle screw. This should get you back on the road. i agree with tombones, but you should also check your needle valve setting
...turn it back in a 1/4 turn this is the ideal setting for your carb. if at this point it is getting too much fuel then your probelm is the needle jet clogged or the float stuck open. if the float is ...
Question about Honda CR 125 R Motorcycles
...turn each adjuster one and one half turns outward. Put the rest of the carb back together, clean the air filter and install the carb. The stock main jet is #165. The number is stamped on the side of ...
...Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas ...
...turn each adjuster one and one half turns outward. Put the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. Please rate this solution. ...
...Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and start the engine. If the bike doesn't start and run properly then shut off the gas and ...
...Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas ...
back together, clean and lightly grease the axle. Also grease the inside of the lip seals for the bearings. Reinstall the wheel, with the hex end of the axle flush with the fork leg. Tighten the pinch
224 questions posted
Usually answered in minutes!
62 Questions
35 Questions
38 Questions
2 Questions
1 Questions